Layer 3 functions
9.3 OSPFv3 (IPv6)
Result
The autonomous system boundary router is enabled.
Further notes
You disable the autonomous system boundary router with the
You enable the distribution of the routes with the
You create the information for the routes with the
You can display the status of this function and other information with the
command.
9.3.3.9
no ASBR Router
Description
With this command, you disable the autonomous system boundary router.
Note
This command is available only with layer 3.
Requirement
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call the command without parameters:
no ASBR Router
Result
The autonomous system boundary router is disabled.
Further notes
You enable the autonomous system boundary router with the
You can display the status of this function and other information with the
command.
590
no ASBR Router
command.
redistribute
command.
redist-config
ASBR Router
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
show ipv6 ospf
command.
show ipv6 ospf