Area Virtual-Link - Siemens SCALANCE XM-400 Configuration Manual

The parameters have the following meaning:
Parameter
area-id
stub
nssa
Result
The area is removed or changed.
9.2.3.9

area virtual-link

Description
With this command, you create a virtual connection to the backbone area.
Note
This command is available only with layer 3. The router must be an Area Border Router
(ABR) or an Autonomous System Boundary Router (ASBR). The router ID must correspond
to the IP address of the interface of the transit area network.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
area <area-id> virtual-link <router-id>
[authentication
{
}
]
[hello-interval <value (1-65535)>]
[retransmit-interval <value(0-3600)>]
[transmit-delay <value (0-3600)>]
[dead-interval <value>]
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Area-ID
Stub area
NSSA area
simple |messagedigest| null
Range of values / note
enter a valid ID.
x.x.x.x
x = 0 ... 255
The area ID 0.0.0.0 is reserved for the backbone area
and cannot be deleted.
--
--
Layer 3 functions
9.2 OSPFv2 (IPv4)
531