Commands In The Global Configuration Mode; Ipv6 Router Ospf - Siemens SCALANCE XM-400 Configuration Manual

9.3.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
9.3.2.1

ipv6 router ospf

Description
With this command, you enable routing with OSPFv3 and change to the Router configuration
mode.
Note
This command is available only with layer 3.
Requirement
● IPv6 routing is activated.
● You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
ipv6 router ospf
Result
Routing with OSPFv3 is enabled.
You are now in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli (config-ospfv3)#
Further notes
You disable routing with OSPFv3 with the
You enable IPv6 routing with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
configure terminal
or
end exit
no ipv6 router ospf
command.
ipv6 unicast-routing
Layer 3 functions
9.3 OSPFv3 (IPv6)
command to change to this mode.
command and are then in the
command.
577