Show Ipv6 Ospf Area-Range - Siemens SCALANCE XM-400 Configuration Manual

Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameter assignment:
show ipv6 ospf virtual-links
Result
The overview is displayed.
9.3.1.12

show ipv6 ospf area-range

Description
This command shows the grouped address ranges.
Note
This command is available only with layer 3.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ipv6 ospf {area-range|summary-prefix}
The parameters have the following meaning:
Parameters
area-range
summary-prefix
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
or
cli#
Description
Grouped area range.
The address range is created with the "area-range"
command.
Grouped address range for OSPFv3
The address range is created with the "summary-
address" command.
Layer 3 functions
9.3 OSPFv3 (IPv6)
Values
-
-
575