No Match Metric - Siemens SCALANCE XM-400 Configuration Manual

The parameter has the following meaning:
Parameter
value
Result
The filter for the value of the metric is created.
Further notes
You delete the filter for the value of the metric with the
You change to the Route maps configuration mode with the command
You display the setting and other information with the
9.8.3.8

no match metric

Description
With this command, you delete the filter for the value of the metric.
Note
This command is available only with layer 3.
Requirement
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
Syntax
Call up the command with the following parameters:
no match metric <value(0-0xffffff)>
The parameter has the following meaning:
Parameter
value
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Value of the metric
Description
Value of the metric
Range of values / note
0 ... 0xffffff
You can enter the value in decimal or hexadecimal.
no match metric
show route-map
Range of values / note
0 ... 0xffffff
You can enter the value in decimal or hexadecimal.
Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
command.
.
route-map
command.
719