Ip Nat Static; No Ip Nat Static - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

ip nat static

With this command, you configure static 1:1 address translations.

You specify which inside global address the inside local address of a device will be

converted to and vice versa. This variant allows connection establishment in both directions.

The device in the internal network can be reached from the external network.

You are in the Interface configuration mode

The command prompt is as follows:

cli(config-if-$$)#

Call up the command with the following parameters:

ip nat static <inside local ip> <inside global ip>

The parameters have the following meaning:

inside local ip

inside global ip

A static address translation is defined.

Further notes

You delete a static address translation with the

You display the current configuration with the

With this command, you delete static 1:1 address translations.

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

Actual address of the device that

should be reachable from external.

Address at which the device will be

reachable from external

Range of values / note

Enter a valid IPv4 address.

no ip nat static

Layer 3 functions

9.9 NAT (IPv4)