Spanning-Tree Auto-Edge; No Spanning-Tree Auto-Edge - Siemens SCALANCE XM-400 Configuration Manual
Simatic net industrial ethernet switches command line interface (cli)
Hide thumbs
Also See for SCALANCE XM-400:
- Configuration manual (832 pages) ,
- Operating instructions manual (80 pages) ,
- Instructions manual (60 pages)
Table of Contents
Advertisement
6.3.5.5
spanning-tree auto-edge
Description
With this command, you enable automatic discovery of a bridge connected to the interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
spanning-tree auto-edge
Result
The automatic discovery of a bridge on the interface is enabled.
Further notes
The automatic discovery of a bridge on the interface is disabled with the
auto-edge
6.3.5.6
no spanning-tree auto-edge
Description
With this command, you disable automatic discovery of a bridge connected to the interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no spanning-tree auto-edge
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
Network structures
6.3 Spanning Tree
no spanning-tree
263
Advertisement
Table of Contents
