Dot1X Reauthentication - Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.7 Port-based Network Access Control (Dot1X)
Syntax
Call up the command with the following parameters:
set dot1x mac-auth mac-addr count <num-of-addresses (1-100)>
The parameter has the following meaning:
Parameter
num-of-addresses
Result
The maximum number of devices for the port has been specified.
Further notes
You display this setting and other information with the
11.7.3.15

dot1x reauthentication

Description
With this command, you enable the 802.1x Re-Authentication function for the selected
interface. When the function is enabled, the authenticator repeats authentication of the client
periodically,
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
dot1x reauthentication
Result
Periodic authentication is enabled for the selected interface.
880
Description
Maximum number of devices
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
1 ... 100
command.
show dot1x
Configuration Manual, 06/2016, C79000-G8976-C252-11