Commands In The Vlan Configuration Mode; Ip Igmp - Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.2 IGMP
8.2.3

Commands in the VLAN configuration mode

This section describes commands that you can call up in the VLAN Configuration mode.
In the Global Configuration mode, enter the
When doing this, you need to replace the
Commands relating to other topics that can be called in the VLAN Configuration mode can
be found in the relevant sections.
● If you exit the VLAN Configuration mode with the
Configuration mode.
● If you exit the VLAN Configuration mode with the
Privileged EXEC mode.
8.2.3.1

ip igmp

Description
With this command, you enable IGMP on an interface.
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call the command without parameter assignment:
ip igmp
Result
IGMP is enabled on the interface.
Further notes
You disable IGMP on an interface with the
You display the setting and other information with the
command.
442
command to change to this mode.
vlan $$$
placeholders with the relevant VLAN ID.
$$$
command, you return to the Global
exit
command, you return to the
end
command.
no ip igmp
show ip igmp global-config
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11