No Area Range - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
Parameter Description
not-advertise
The address range is not advertised to the outside.
summary
LSA type 3: Inter-area prefix LSA
Type7
LSA type 7
tag
Keyword for tag:
tag-value
Value that is assigned to the aggregated routes.
(optional)
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The address range is configured.
Further notes
You delete the address range with the
You configure the area with the
You can display the status of this function and other information with the
area-range
9.3.3.5

no area range

Description
With this command, you delete the address range.
Note
This command is available only with layer 3.
Requirement
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
584
area
command.
Range of values / note
-
-
-
-
1 ... 65535
command.
no area range
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
show ipv6 ospf