No Authorized-Manager Ip-Source - Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.6 Management Access Control List
Result
The interfaces and protocols via which an authorized manager is allowed to access the
device are configured.
Note
No restrictions for console port
The restrictions do not apply to the serial console (console port).
Further notes
You delete an interface for access of an authorized manager with the
ip-source
You show the information about the configuration of the authorized managers with the
authorized-manager
11.6.2.4

no authorized-manager ip-source

Description
With this command, you delete an interface via which an authorized manager is allowed to
access the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no authorized-manager ip-source <ip-address>
[{<subnet-mask>|/<prefix-length(0-32)>}]
The parameters have the following meaning:
Parameter
ip-address
subnet-mask
prefix-length
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
864
command.
command.
Description
Specifies the network or the IP address
for which the IP manager is authorized
Subnet mask that restricts the authori-
zation
Decimal representation of the mask as
a number of "1" bits
Range of values / note
Enter a valid IP address or a
network
Enter a valid mask
0 ... 32
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
no authorized-manager
show