Show Ipv6 Static Route; Commands In The Global Configuration Mode; Ipv6 Neighbor - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.2 IPv6 protocol
Further notes
You reset the counters to zero with the
7.2.2.6

show ipv6 static route

Description
This command shows the routes that were generated statically.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show ipv6 static route
Result
The static routes are displayed.
7.2.3

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
7.2.3.1

ipv6 neighbor

Description
With this command, you configure a static entry in the IPv6 neighbors table.
310
or
cli#
clear ipv6 traffic
command to change to this mode.
configure terminal
or
end exit
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
command and are then in the