The parameter has the following meaning:
Parameter
Value
Result
The priority is specified.
Further notes
You can reset the priority to the default with the
You display the router ID and other information with the
9.2.4.18
no ip ospf priority
Description
With this command, you reset the value for the priority to the default value.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if)#
Syntax
Call the command without parameter assignment:
no ip ospf priority
Result
The value for the priority is reset to the default.
Further notes
You configure the priority with the
You display the router ID and other information with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Priority
ip ospf priority
Range of values / note
0 ... 255
Default: 1
command.
no ip ospf priority
show ip ospf interface
command.
show ip ospf interface
Layer 3 functions
9.2 OSPFv2 (IPv4)
command.
command.
565