Further notes
You enable OSPFv3 routing with the
You configure the metric with the
You display the configuration with the
9.3.4.9
ipv6 ospf passive-interface
Description
With this command, you deactivate the OSPF interface. The router then does not send any
hello packets on this interface and can also not establish a link via this interface.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
ipv6 ospf passive-interface
Result
The OSPF interface is inactive.
Further notes
You enable OSPFv3 routing with the
You enable the interface with the no ipv6 ospf passive-interface command.
You display the configuration with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
ipv6 router ospf
command.
ipv6 ospf metric
show ipv6 ospf interface
command.
ipv6 router ospf
show ipv6 ospf interface
Layer 3 functions
9.3 OSPFv3 (IPv6)
command.
command.
609