Siemens SCALANCE XM-400 Configuration Manual page 582

Layer 3 functions
9.3 OSPFv3 (IPv6)
Syntax
Call up the command with the following parameters:
area <Area-ID> range
<IPv6-Prefix> / <Prefix-Length>
[{
advertise | not-advertise
}]
[tag <value>] [cost <cost>]
The parameters have the following meaning:
Parameter Description
Area-ID
Area ID
IPv6-Prefix
IPv6 address
Prefix-Length
Number of bits belonging to the prefix
(from left to right)
advertise
The address range is advertised outside the ranges. A
summary LSA of type 3 is generated.
not-advertise
The address range is not advertised to the outside.
tag
Keyword for tag:
value
Value that is assigned to the aggregated routes.
cost
Keyword for the costs
value
Costs for the OSPF interface.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The address range is configured.
Further notes
You delete the address range with the
You configure the area with the
You can display the status of this function and other information with the
area-range
582
area
command.
Range of values / note
specify the ID in the IPv4 address
format
x.x.x.x = 0 ... 255
0.0.0.0 = backbone area
enter a valid IPv6 address
1 ... 128 bits
128: The node (host) itself
-
-
-
1 ... 65535
-
1 ... 65535
command.
no area range
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
show ipv6 ospf