Further notes
You display this setting and other information with the
You disable RIP routing with the
9.7.4.4
no ipv6 rip
Description
This command disables RIPng routing on the interface.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no ipv6 rip
Result
RIPng routing is enabled.
Further notes
You display this setting and other information with the
You enable RIP routing with the
9.7.4.5
ipv6 rip metric-offset
Description
As default. the metric increases by 1 (metric offset) with incoming RIPng routes. With this
command, you can specify a different offset. The RIPng route is further distributed with the
new metric.
Note
This command is available only with layer 3.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
show ipv6 rip
command.
no ipv6 rip
show ipv6 rip
command.
ipv6 rip.
Layer 3 functions
9.7 RIPng (IPv6)
command.
command.
707