Commands In The Global Configuration Mode; Ip Pim Routing - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
ip pim clear counters [{vlan <vlan-id>}]
The parameters have the following meaning:
Parameter
vlan
vlan-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Note
PIM does not support any router ports.
If no parameters are specified, the settings for all interfaces are displayed.
Result
The counters of the interface are reset.
9.10.3

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
9.10.3.1

ip pim routing

Description
With this command, you enable PIM globally on the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Keyword for a VLAN connection
Number of the addressed VLAN
configure terminal
Range of values / note
-
1 ... 4094
command to change to this mode.
or command and are then in the
end exit
Layer 3 functions
9.10 PIM (IPv4)
761