Dot1X Mac-Auth; No Dot1X Mac-Auth - Siemens SCALANCE XM-400 Configuration Manual

11.7.2.3

dot1x mac-auth

Description
With this command, you enable MAC authentication for the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
dot1x mac-auth
Result
MAC authentication is enabled for the device.
Further notes
You also still need to enable MAC authentication for every port intended to use this function.
You do this with the
You disable the function with the
You display this setting and other information with the
11.7.2.4

no dot1x mac-auth

Description
With this command, you disable MAC authentication for the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no dot1x mac-auth
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command in the Interface configuration mode.
dot1x mac-auth
no dot1x mac-auth
Security and authentication
11.7 Port-based Network Access Control (Dot1X)
command.
command.
show dot1x
869