Network structures
6.1 VLAN
Syntax
Call up the command with the following parameters:
show subnet-vlan mapping
The parameters have the following meaning:
Parameter
interface
interface-type
interface-id
switch
string
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameter from the parameter list, all entries are displayed.
Result
The entries of the subnet VLAN table are displayed.
6.1.1.8
show vlan
Description
This command shows the specific information for all or a selected VLAN.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show vlan[brief|id<vlan-range>|summary]
The parameters have the following meaning:
Parameter
brief
id
186
[{interface<interface-type><interface-id>|switch<string(32)>}]
Description
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Keyword for a switch
Name of the switch
or
cli#
Description
Shows brief information about all
VLANs
Keyword for a VLAN or VLAN range
Range of values / note
-
Enter a valid interface.
-
max. 32 characters
Range of values / note
-
-
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11