Syntax
Call up the command with the following parameters:
show ip pim interface [vlan <vlan-id(1-4094)>] detail
The parameters have the following meaning:
Parameter
vlan
vlan-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If no parameters are specified, the settings for all interfaces are displayed.
Result
Detailed settings for PIM are displayed.
Further notes
You enable PIM globally on the device with the
You assign an interface to PIM with the
9.10.1.3
show ip pim neighbor
Description
With this command, you display the PIM neighborhood table.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ip pim neighbor [ vlan <vlan-id(1-4094)>]
The parameters have the following meaning:
Parameter
vlan
vlan-id
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Keyword for a VLAN connection
Number of the addressed VLAN
or
cli#
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Range of values / note
-
1 ... 4094
ip pim routing
command.
ip pim
Range of values / note
-
1 ... 4094
Layer 3 functions
9.10 PIM (IPv4)
command.
755