Diagnostics
12.5 RMON
Result
The event is configured.
Further notes
You delete an entry with the
You display the RMON Event Table with the
You show the details of the SNMP community with the
12.5.2.6
no rmon event
Description
With this command, you delete an entry from the RMON event table.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no rmon event <number (1-500)>
The parameter has the following meaning:
Parameter
number
Result
The entry is deleted from the RMON event table.
12.5.3
Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
940
command.
no rmon event
show rmon events
Description
Number of the event entry to be delet-
ed
interface
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
command.
show snmp community
Range of values / note
1 ... 500
command to change to this mode.
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.