Layer 3 functions
9.9 NAT (IPv4)
Result
The current NAT/NAPT configuration of the interfaces is displayed.
Further notes
You enable NAT for the selected IP interface with the
configuration mode.
You disable NAT for the selected IP interface with the
configuration mode.
You enable NAPT for the selected IP interface with the
Interface configuration mode.
You disable NAPT for the selected IP interface with the
Interface configuration mode.
9.9.1.5
show ip nat
Description
This command shows address translations or active connections depending on the selected
parameter.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ip nat { interface | static | translations}
The parameters have the following meaning:
Parameter
interface
static
translations
Result
The configured address translations or active connections are displayed.
738
or
cli#
Description
Shows the configuration of the dynamic address
translations.
Shows the configuration of the static 1:1 address
translations.
Displays the active NAT connections.
command in the Interface
ip nat
command in the Interface
no ip nat
ip nat napt
no ip nat napt
Range of values / note
-
-
-
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command in the
command in the