No Event Config - Siemens SCALANCE XM-400 Configuration Manual

Parameter
faultstate-change
stp-change
vrrp-state-change
loopd-state-change
ospf-state-change
dot1x-port-auth-
state-change
poe-state-change
fmp-state-change
all
logtable
syslog
email
trap
faults
env-data-change
all
Result
The setting deciding which message of the device is stored or forwarded is configured.
Further notes
You display the status of the events and the clients with the
You delete the settings with the
With this command, the clients are not enabled.
To enable the clients, use the
Note
Changing several message types or clients
With each command call, you can only select one message type and one client.
If you want to process several message types or clients, it may be more efficient to first
select the
12.1.6.5

no event config

Description
With this command, you configure which of the various message types of the device will no
longer be stored or forwarded.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Message when there is a status change in the error monitoring
Message when there is a change in the spanning tree
Message on status change of VRRP routers
Message if there is a status change in the detection of network loops
Message on status change of OSPF routers
Message when there is a status change in the 802.1X authentication
Message on status change of PoE
Message on status change of FMP
All messages
Client that processes the logbook entries
Client that sends the messages to the Syslog server
Client that sends the e-mails
Client that sends the SNMP traps
Error LED lights up. The setting is possible only for a cold or warm restart.
Message when there is a status change in the diagnostics data
All clients at once
no event config
client config
option and then disable individual elements.
all
12.1 Event and fault handling
show events config
command.
command.
Diagnostics
command.
897