Redistribute - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.6 RIPv2 (IPv4)
Syntax
Call up the command with the following parameters:
no network <ip-address>
The parameter has the following meaning:
Parameter
ip-address
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
RIP is disabled for the specified IP interface.
9.6.3.9

redistribute

Description
This command specifies which route information is forwarded by RIP.
Requirement
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
Syntax
Call up the command with the following parameters:
redistribute {all | default | connected | ospf | static} [route-map <name(20)>]
The parameters have the following meaning:
Parameter
all
default
connected
ospf
static
route-map
name
684
Description
The IP address for which RIP will be
disabled.
Description
All available route information is dis-
tributed.
Default routes are distributed.
Routing information of local subnets (IP
interfaces) is distributed for which RIP
is not configured.
Routes learned by OSPF are distribut-
ed.
Static routes are distributed.
Keyword for a route map.
Name of the route map.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
Specify a valid IP address.
Range of values / note
-
-
-
-
-
-
Maximum of 20 characters
Configuration Manual, 06/2016, C79000-G8976-C252-11