Layer 3 functions
9.2 OSPFv2 (IPv4)
9.2.3.2
no ASBR Router
Description
With this command, you disable the autonomous system boundary router.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call the command without parameters:
no ASBR Router
Result
The autonomous system boundary router is disabled.
Further notes
You enable the autonomous system boundary router with the
You can display the status of this function and other information with the
command.
9.2.3.3
area range
Description
With this command, you assign an area ID an address range. The address range is used to
group the routes within OSPF.
Note
This command is available only with layer 3.
524
ASBR Router
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
show ip ospf