Layer 3 functions
9.3 OSPFv3 (IPv6)
Syntax
Call the command without parameter assignment:
show ipv6 ospf areas
Result
The information is displayed.
9.3.1.4
show ipv6 ospf border-routers
Description
This command shows the OSPFv3 routes to the area border routers and to the AS boundary
routers.
Note
This command is available only with layer 3.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show ipv6 ospf border-routers
Result
The OSPFv3 routers are shown.
9.3.1.5
show ipv6 ospf host
Description
This command shows the SMS host table
Note
This command is available only with layer 3.
570
or
cli#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11