Show Ip Igmp Snooping Switch-Ip; Commands In The Global Configuration Mode - Siemens SCALANCE XM-400 Configuration Manual

Result
The statistical information is displayed.
8.3.1.7

show ip igmp snooping switch-ip

Description
This command shows the IP address of the source for IGMP snooping.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show ip igmp snooping switch-ip
Result
The IP address is displayed.
8.3.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
command to change to this mode.
configure terminal
or
end exit
Layer 2 management protocols
8.3 IGMP snooping
command and are then in the
461