Result
The selected property is configured.
Further notes
You can reset the setting to the default with the
You display these settings and other information with the commands that start with
spanning tree ...
6.3.5.2
no spanning-tree
Description
With this command, you reset the various properties of the spanning tree function to the
default value:
The default values are as follows:
Parameter
cost
disable
link-type
portfast
port-priority
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no spanning-tree {cost|disable|link-type|portfast|port-priority}
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
.
Default value
if dynamic calculation of the path costs is not enabled:
200000 for physical interfaces
•
199999 for port channels
•
The spanning tree function is enabled on the interface
•
point-to-point
The connection is configured as
•
shared
in all other cases
disabled
128
(properties) command.
no spanning-tree
full-duplex
Network structures
6.3 Spanning Tree
show
259