Commands In The Global Configuration Mode; Events - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call the command without parameters:
clear logbook
Result
The content of the logbook is deleted.
12.1.5

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
12.1.5.1

events

Description
With this command, you change to the EVENTS configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
events
Result
You are now in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command to change to this mode.
configure terminal
or
end exit
Diagnostics
12.1 Event and fault handling
command and are then in the
891