Commands In The Interface Configuration Mode; Channel-Group - Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.2 Link aggregation
6.2.3

Commands in the interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
6.2.3.1

channel-group

Description
With this command, you add an interface to an Etherchannel.
Requirement
With the
logical interface for an Etherchannel.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
channel-group <channel-group-number(1-8)> mode{on|active|passive}
The parameters have the following meaning:
Parameter
channel-group-
number
on
232
interface po <channel-group-id(1-8)>
Description
Number of the Channel-Group
Adds the interface without LACP to a
Channel-Group.
This corresponds to manual bundling.
command to change to this mode.
interface
command, you return to the
exit
command, you return to the
end
command, you have already generated a
Range of values / note
1 ... 8
If you add a configured port to a
link aggregation, the port adopts
the configuration of the link ag-
gregation. If you take the port out
of the link aggregation, the set-
tings of the port are reset to the
factory settings.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11