Sntp Unicast-Server - Siemens SCALANCE XM-400 Configuration Manual

System time
5.3 SNTP Client
Parameter
hh
mm
Enter the time difference as follows:
● with sign
● without spaces
● Hours and minutes both two digits (with leading zero)
Default: no time difference
Result
The time zone of the system time is configured.
Further notes
You can display the settings of this function and other information with the
status
5.3.3.3

sntp unicast-server

Description
With this command, you configure an SNTP unicast server.
Requirement
● The addressing mode of the SNTP client is configured as "unicast".
● You are in the SNTP Configuration mode.
The command prompt is:
cli(config-sntp)#
Syntax
Call up the command with the following parameters:
sntp unicast-server {ipv4 <ucast_addr> | fqdn-name <FQDN> | ipv6 <ip6_addr>}
[port<1025-36564>][poll<seconds(16-16284)>] [secondary]
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
fqdn-name
170
Description
Number of hours difference
Number of minutes difference
command.
Description
Keyword for an IP address
Value for an IPv4 unicast address
Keyword for a domain name
Range of values / note
-
Enter a valid IPv4 unicast ad-
dress.
-
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
show sntp