No Snmp Targetparams; Snmp V1-V2 Readonly - Siemens SCALANCE XM-400 Configuration Manual

Further notes
You delete the SNMP target parameters with the
You display settings of this function with the
You configure the user profile with the
You display the list of users with the
7.8.2.17

no snmp targetparams

Description
With this command, you delete the SNMP target parameters.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp targetparams <ParamName>
The parameter has the following meaning:
Parameter
ParamName
Result
The SNMP target parameters are deleted.
Further notes
You change the SNMP target parameters with the
You display settings of this function with the
7.8.2.18

snmp v1-v2 readonly

Description
With this command, you block write access for SNMPv1 and SNMPv2 PDUs.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
show snmp targetparam
snmp user
show snmp user
Description
Name of the SNMP parameter
show targetparam
command.
no snmp targetparams
command.
command.
command.
Range of values / note
max. 32 characters
command.
snmp targetparams
command.
Network protocols
7.8 SNMP
407