No Match Metric-Type - Siemens SCALANCE XM-400 Configuration Manual

Further notes
You delete the filter for the type of the metric with the
You change to the Route maps configuration mode with the command
You display the setting and other information with the
9.8.3.10

no match metric-type

Description
With this command, you delete the filter for the type of the metric.
Note
This command is available only with layer 3.
Requirement
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
Syntax
Call up the command with the following parameters:
no match metric-type {inter-area | intra-area | type-1-external | type-2-external }
The parameters have the following meaning:
Parameter
inter-area
intra-area
type-1-external
type-2-external
Result
The filter for the type of the metric is deleted.
Further notes
You create a filter for the type of the metric with the
You change to the Route maps configuration mode with the command
You display the setting and other information with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Routes learnt from different areas
Routes that originate from the same area
Routes whose path costs (metric) are made up from the
external path costs and the patch costs to the ASBR
Routes with only external path costs (metric)
9.8 Route maps (IPv4 / IPv6)
no match metric-type
route-map
command.
show route-map
Range of values / note
-
-
-
-
command.
match metric-type
route-map
command.
show route-map
Layer 3 functions
command.
.
.
721