No Spanning-Tree Mst Max-Hops - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
spanning-tree mst max-hops <value(6-40)>
The parameter has the following meaning:
Parameter
value
Result
The setting for the maximum number of hops is configured.
Further notes
You can reset the setting for the maximum number of nodes to the default with the
spanning-tree mst max-hops
You display this setting and other information with the
configuration
6.3.4.7

no spanning-tree mst max-hops

Description
With this command, you reset the maximum number of hops that a path in an MST can run
through to the default value.
The default value is 20.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no spanning-tree mst max-hops
Result
The setting for the maximum number of nodes is reset to the default value.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Maximum number of hops that a path
can run through in an MST
command.
command.
Network structures
6.3 Spanning Tree
Range of values / note
6 ... 40
Default: 20
show spanning tree mst
no
249