Distribute-List Route-Map - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
Syntax
Call up the command with the following parameters:
no redistribute {static | connected | rip | default | all}
The parameters have the following meaning:
Parameter
static
connected
rip
default
all
Result
Which routes are distributed via OSPF is disabled.
Further notes
You enable the distribution of the routes with the
9.2.3.23

distribute-list route-map

Description
This command enables the filtering of the routing information according to a route map for
incoming routing information.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
distribute-list route-map <name(1-20)> in
The parameters have the following meaning:
Parameter
name
in
546
Description
static routes
connected routes
RIP routes
standard routes
all routes
Description
Name of the routing table.
Incoming routing information is filtered.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
command.
redistribute
Range of values / note
Maximum of 20 characters.
-
Configuration Manual, 06/2016, C79000-G8976-C252-11