Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
9.5.5.5
vrrp compatible-mode
Description
With this command, you enable compatibility with VRRPv2. For configured IPv4 addresses,
when enabled, the VRRP router sends and receives VRRPv2 frames in addition to VRRPv3
frames. Only necessary when not all VRRP routers support VRRPv3.
Note
This command is available only with layer 3.
Requirement
● An IP address is assigned to the virtual router.
● You are in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
Syntax
Call up the command with the following parameters:
vrrp <vrid(1-255)> compatible-mode
The parameter has the following meaning:
Parameter
vrid
Result
The compatibility is enabled.
Further notes
You enable routing with VRRP3 with the
You assign IP addresses to a virtual router with the
You disable the compatibility with the
You can display the status of the function with the
interface
664
Description
ID of the virtual router
command.
command.
router vrrp3
vrrp associated-ip
no vrrp compatible-mode
show vrrp3
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Range of values / note
1 ... 255
command.
command.
or with the
show vrrp3