No Router Ospf; Commands In The Router Configuration Mode - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
9.2.2.2

no router ospf

Description
With this command, you disable routing with OSPF.
Note
This command is available only with layer 3.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no router ospf
Result
Routing with OSPF is disabled.
Further notes
You enable routing with OSPF with the
9.2.3

Commands in the Router Configuration mode

This section describes commands that you can call up in the Router configuration mode.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
● If you exit the Router configuration mode with the
configuration mode.
● If you exit the Router configuration mode with the
Privileged EXEC mode.
522
command.
router ospf
command to change to this mode.
router ospf
command, you return to the Global
exit
command, you return to the
end
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11