Syntax
Call the command without parameters:
dot1x mac-auth
Result
MAC authentication is enabled for a port.
Further notes
You also still need to enable MAC authentication for the device. You do this with the
mac-auth
You disable the function with the
You display this setting and other information with the
11.7.3.8
no dot1x mac-auth
Description
With this command, you disable MAC authentication for a port.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no dot1x mac-auth
Result
MAC authentication is disabled for a port.
Further notes
You enable the function with the
You display this setting and other information with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command in the Global configuration mode.
11.7 Port-based Network Access Control (Dot1X)
command.
no dot1x mac-auth
show dot1x
command.
dot1x mac-auth
show dot1x
Security and authentication
dot1x
command.
command.
875