No Redistribute - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
9.3.3.19

no redistribute

Description
With this command, you disable distribution of routes with OSPFv3.
Note
This command is available only with layer 3.
Requirement
● The router is an ASBR router.
● You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call up the command with the following parameters:
no redistribute {static | connected | ripng | bgp }
The parameters have the following meaning:
Parameter
static
connected
ripng
bgp
Result
The routes are specified that are not distributed via OSPFv3.
Further notes
You enable the ASBR router with the
You enable the distribution of the routes with the
You display the setting with the
600
Description
static routes
connected routes
RIPng routes
BGP routes
ASBR Router
show ipv6 ospf
Range of values / note
-
-
-
-
command.
command.
redistribute
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11