Ipv6 Address Dhcp Stateless - Siemens SCALANCE XM-400 Configuration Manual

Result
The setting is configured.
Further notes
You disable the setting with the
You configure the interface as a router port with the
You show the setting with the
You can display the statistics of the DHCPv6 client with the
statistics
7.2.4.4

ipv6 address dhcp stateless

Description
With this command, you enable DHCPv6. The interface however only obtains the
configuration setting via DHCPv6.
Requirement
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
ipv6 address dhcp
Result
The interface only obtains the configuration setting via DHCPv6.
Further notes
You disable DHCPv6 with the
You configure the interface as a router port with the
You show the setting with the
You can display the statistics of the DHCPv6 client with the
statistics
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
no ipv6 address dhcp
show ipv6 dhcp interface
command.
no ipv6 address dhcp
show ipv6 dhcp interface
command.
Network protocols
command.
command.
no switchport
command.
show ipv6 dhcp client
command.
command.
no switchport
command.
show ipv6 dhcp client
7.2 IPv6 protocol
323