No Dot1X Port-Control; Set Dot1X Mac-Auth Mac-Addr Count - Siemens SCALANCE XM-400 Configuration Manual

11.7.3.13

no dot1x port-control

Description
With this command, you reset the port control parameter of the authenticator to the default
value.
The default value is
With this, data traffic is permitted without restrictions.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no dot1x port-control
Result
The port control parameter of the authenticator is reset to the default value.
Further notes
You configure the port control parameter with the
You can display the status of this function and other information with the
dot1x
11.7.3.14

set dot1x mac-auth mac-addr count

Description
With this command, you specify how many MAC addresses can be authenticated on the port
at the same time.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
force-authorized
command.
11.7 Port-based Network Access Control (Dot1X)
.
dot1x port-control
Security and authentication
command.
show
879