Dot1X Port-Control - Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.7 Port-based Network Access Control (Dot1X)
11.7.3.12

dot1x port-control

Description
With this command, you configure port control parameter of the authenticator.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
dot1x port-control {auto|force-authorized|force-unauthorized}
The parameters have the following meaning:
Parameter
auto
force-authorized
force-unauthorized
Result
The port control parameter is configured.
Further notes
You can reset the port control parameter to the default with the
command.
You can display the status of this function and other information with the
dot1x
878
Description
Authentication according to IEEE
802.1x is enabled for the interface.
The data traffic via the interface is
permitted or blocked depending on the
authentication result.
data traffic via the interface is permitted
without restrictions
data traffic via the interface is blocked
command.
Range of values / note
-
Default:
bled
-
no dot1x port-control
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
ena-
force-authorized
show