Network protocols
7.5 DHCP server
You configure the DHCP options 12, 66 and 67 with the
You configure the interface with the
7.5.3.4
option value-string
Description
With this command you configure DHCP options 12, 66 and 67 that contain a string as
DHCP parameter. The DHCP options 66 and 67 are created automatically when the IPv4
address band is created.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
option <option-code> value-string <dhcp-param>
The parameters have the following meaning:
Parameter
option-code
dhcp-param
Result
The DHCP option is configured.
Further notes
You display the setting with the
You delete the DHCP option with the
You configure the DHCP options 3 and 6 with the
You disable the IPv4 address band with the
356
set interface
Description
Code of the DHCP option
Name of the file
show ip dhcp-server pools
no option
option value-string
command.
Range of values / note
12 - Host name
•
66 - TFTP server
•
67 - Bootfile name
•
Enter the name in the string format.
command.
command.
(IP address) command.
option
command.
no pool-enable
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.