Configuration
3.1 System
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If no parameters are specified, the settings for all ports are displayed.
Result
The multicast blocking settings for ports are displayed.
3.1.1.14
show pnio
Description
This command shows the current PROFINET configuration.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
This
Syntax
Call the command without parameters:
show pnio
Result
The current PROFINET configuration is displayed.
3.1.1.15
show traceroute
Description
This command shows the route via which the packet comes to the requested IP address-
70
Description
Keyword for a port description
Type of interface
Module no. and port no. of the interface
or
cli>
cli#
Range of values / note
-
Enter a valid interface
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11