Show Ip Ospf Neighbor - Siemens SCALANCE XM-400 Configuration Manual

9.2.1.7

show ip ospf neighbor

Description
This command shows information about the detected neighboring routers.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ip ospf neighbor
[{
vlan <vlan-id(1-4094)>|<interface-type><interface-id>
}]
[Neighbor ID]
[detail]
The parameters have the following meaning:
Parameter
Vlan
vlan-id
interface-type
interface-id
Neighbor ID
detail
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The information on the neighboring routers is displayed.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
Router ID of the neighbor
OSPF information on the neighbor
Layer 3 functions
9.2 OSPFv2 (IPv4)
Range of values / note
-
1 ... 4094
Enter a valid interface.
The ID consists of 4 numbers
each between 0 and 255 and can
match the IP address of the rout-
er.
-
517