12.4.2.4
no monitor barrier enabled
Description
With this command, you enable the communication via the monitor port.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no monitor barrier enabled
Result
Communication via the monitor port is enabled.
Further notes
You disable the communication with the
You display the configuration settings with the
12.4.2.5
monitor session destination
Description
With this command, you configure the destination for mirroring a port.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
monitor session <session-id(1-7)> destination
{interface <interface-type><interface-id> | remote vlan <vlan-id (1-4094)>}
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
monitor barrier enabled
show monitor barrier
Diagnostics
12.4 Port Mirroring
command.
command.
927