No Vrrp Text-Authentication - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

no vrrp text-authentication

Was this command, you specify that VRRP packets are not authenticated.

This command is available only with layer 3.

● An IPv4 address is assigned to the virtual router.

● You are in the VRRP Interface configuration mode

.The command prompt is:

cli(config-vrrp-if)#

Call up the command with the following parameters:

no vrrp <vrid(1-255)> text-authentication

The parameter has the following meaning:

The authentication is disabled.

Further notes

You configure a VRRP interface with the

You enable the authentication with the

You assign IPv4 addresses to a virtual router with the

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

ID of the virtual router

vrrp text-authentication

9.4 VRRPv2 (IPv4)

Range of values / note

vrrp associated-ip

Layer 3 functions