Commands In The Global Configuration Mode; Router Vrrp3 - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call the command without parameter assignment:
show vrrp3 track
Result
The configured interface tracking is displayed.
9.5.3

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
9.5.3.1

router vrrp3

Description
With this command, you enable routing with VRRPv3 and change to the VRRP3 Router
configuration mode.
Note
This command is available only with layer 3.
Requirement
● IPv6 routing is enabled.
● You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
router vrrp3
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command to change to this mode.
configure terminal
or
end exit
Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
command and are then in the
649