Layer 3 functions
9.3 OSPFv3 (IPv6)
9.3.2.2
no ipv6 router ospf
Description
With this command, you disable routing with OSPFv3.
Note
This command is available only with layer 3.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no ipv6 router ospf
Result
Routing with OSPFv3 is disabled.
Further notes
You enable routing with OSPFv3 with the
9.3.3
Commands in the Router configuration mode
This section describes commands that you can call up in the Router Configuration mode.
In the global configuration mode, enter the
mode.
Commands relating to other topics that can be called in the Global Configuration mode can
be found in the relevant sections.
● If you exit the Router Configuration mode with the
Global Configuration mode.
● If you exit the Router Configuration mode with the
Privileged EXEC mode.
578
command.
ipv6 router ospf
command to change to this
ipv6 router ospf
command, you return to the
exit
command, you return to the
end
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11