No Standby Wait-For-Partner - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

no standby wait-for-partner

With this command, you disable the "Wait for standby partner" function on the device. A

standby connection is enabled even if the standby master has not yet established a

connection to the standby slave.

You are in the Redundancy configuration mode.

The command prompt is as follows:

cli(config-red)#

Call the command without parameters:

no standby wait-for-partner

The "Wait for standby partner" function is disabled.

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

Layer 2 management protocols